H3C LS-3100-52P-OVS-H3 Operation Manual - page 293
1-12
To do…
Use the command…
Remarks
Specify the current device as
the master node of the ring,
and specify the primary port
and the secondary port
ring ring-id node-mode master
[ primary-port interface-type
interface-number ]
[ secondary-port interface-type
interface-number] level
level-value
Required
Configure the timer for the
RRPP domain
timer hello-timer hello-value
fail-timer fail-value
Optional
By default, the Hello timer
value is 1 second and the Fail
timer value is 3 seconds.
Enable the RRPP ring
ring ring-id enable
Required
By default, the RRPP ring is
disabled.
Return to system view
quit
—
Enable RRPP
rrpp enable
Required
By default, RRPP is disabled.
z
Before specifying RRPP rings for an RRPP domain, you must specify protected VLANs for the
domain.
z
Before specifying rings for an RRPP domain, you can delete or modify the protected VLANs
configured for the RRPP domain; after specifying rings for an RRPP domain, you can delete or
modify the protected VLANs configured for the RRPP domain, however, you cannot delete all the
protected VLANs configured for the domain.
z
Deleting an RRPP domain deletes its protected VLANs at the same time.
z
The protected-vlan command configures protected VLANs for an RRPP domain by referencing
MSTIs to which the protected VLANs are mapped. You can use the display stp
region-configuration command to view the VLAN-to-MSTI mappings. For detailed information
about VLAN-to-MSTI mapping configuration, refer to MSTP Configuration in the Access Volume.
z
The control VLAN configured for an RRPP domain must be a new one.
z
Control VLAN configuration is required for configuring an RRPP ring.
z
To use the undo rrpp domain command to remove an RRPP domain, you must ensure the RRPP
domain has no RRPP ring.
z
Before removing or modifying the control VLAN of an RRPP domain, make sure that the RRPP
domain is not configured with any RRPP ring.
Configuring Transit Node
Follow these steps to configure transit node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create an RRPP domain and
enter its view
rrpp domain domain-id
Required