H3C LS-3100-52P-OVS-H3 Operation Manual - page 295
1-14
Configuring Edge Node
Follow these steps to configure edge node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Create an RRPP domain and
enter its view
rrpp domain domain-id
Required
Specify a control VLAN for the
RRPP domain
control-vlan vlan-id
Required
Specify protected VLANs for
the RRPP domain
protected-vlan
reference-instance
instance-id-list
Required
No protected VLAN is specified
for an RRPP domain by
default.
Specify the current device as
the transit node of the primary
ring, and specify the primary
port and the secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ]
[ secondary-port interface-type
interface-number] level
level-value
Required
Specify the current device as
the edge node of a subring,
and specify the edge port
ring ring-id node-mode edge
[ edge-port interface-type
interface-number ]
Required
Enable the primary ring
ring ring-id enable
Required
By default, the RRPP ring is
disabled.
Enable the subring
ring ring-id enable
Required
By default, the RRPP ring is
disabled.
Return to system view
quit
—
Enable RRPP
rrpp enable
Required
By default, RRPP is disabled.