H3C LS-3100-52P-OVS-H3 Operation Manual - page 1199
1-11
To do…
Use the command…
Remarks
Enter IPv6 address family view ipv6-family
—
Enable IPv6 BGP route refresh
for a peer/peer group
peer { ipv6-group-name |
ipv6-address }
capability-advertise
route-refresh
Optional
Enabled by default
Perform a manual soft-reset
If the peer does not support route-refresh, you can use the peer keep-all-routes command to save all
the route updates from the peer, and then use the refresh bgp ipv6 multicast command to soft-reset
IPv6 MBGP connections to refresh the IPv6 MBGP routing table and apply the new policy without
tearing down IPv6 MBGP connections.
Follow these steps to perform a manual soft-reset
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 MBGP address
family view
ipv6-family multicast
—
Keep all routes from a
peer/peer group regardless of
whether they pass the inbound
filtering policy
peer { ipv6-group-name |
ipv6-address } keep-all-routes
Required
Not kept by default
Exit to user view
return
—
Soft-reset IPv6 MBGP
connections manually
refresh bgp ipv6 multicast
{all | ipv6-address | group
ipv6-group-name | external |
internal } { export | import }
Optional
Configuring the Maximum Number of Equal-Cost Routes for Load-Balancing
Follow these steps to configure the maximum number of equal-cost routes for load-balancing:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 MBGP address
family view
ipv6-family multicast
—
Configure the maximum
number of equal-cost routes for
load balancing
balance number
Required
By default, load balancing is
disabled.