H3C LS-3100-52P-OVS-H3 Operation Manual - page 129
1-6
z
Do not set the voice VLAN as the default VLAN of a port in automatic voice VLAN assignment
mode. Otherwise, the system prompts error information. For information about voice VLAN, refer to
Voice VLAN Configuration
.
z
The local and remote ports must use the same default VLAN ID for the traffic of the default VLAN to
be transmitted properly.
A port configured with the default VLAN handles a frame as follows:
Actions (in the inbound direction)
Port type
Untagged frame
Tagged frame
Actions (in the
outbound direction)
Access
Tag the frame with
the default VLAN
tag.
z
Receive the frame if its
VLAN ID is the same as the
default VLAN ID.
z
Drop the frame if its VLAN
ID is different from the
default VLAN ID.
Remove the default VLAN
tag and send the frame.
Trunk
z
Remove the tag and
send the frame if the
frame carries the
default VLAN tag.
z
Send the frame without
removing the tag if its
VLAN is carried on the
port but is different
from the default one.
Hybrid
Check whether the
default VLAN is
permitted on the
port:
z
If yes, tag the
frame with the
default VLAN
tag.
z
If not, drop the
frame.
z
Receive the frame if its
VLAN is carried on the port.
z
Drop the frame if its VLAN
is not carried on the port.
Send the frame if its VLAN
is carried on the port. The
frame is sent with the
VLAN tag removed or
intact depending on your
configuration with the port
hybrid vlan command.
This is true of the default
VLAN.
Assigning an Access Port to a VLAN
You can assign an access port to a VLAN in VLAN view, interface view, or port group view.
1) In VLAN view
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter VLAN view
vlan vlan-id
Required
If the specified VLAN does not exist,
this command creates the VLAN first.