H3C LS-3100-52P-OVS-H3 Operation Manual - page 627
1-17
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enter IS-IS view
isis [ process-id ]
[ vpn-instance
vpn-instance-name ]
––
Specify the IS level
is-level { level-1 | level-1-2 |
level-2 }
Optional
The default is Level-1-2.
Return to system view
quit
––
Enter interface view
interface interface-type
interface-number
––
Specify the circuit level
isis circuit-level [ level-1 |
level-1-2 | level-2 ]
Optional
The default is Level-1-2.
Configuring the Network Type of an Interface as P2P
Interfaces with different network types operate differently. For example, broadcast interfaces on a
network need to elect the DIS and flood CSNP packets to synchronize the LSDBs, while P2P interfaces
on a network need not elect the DIS and have a different LSDP synchronization mechanism.
If there are only two routers on a broadcast network, you can configure the network type of attached
interfaces as P2P to avoid DIS election and CSNP flooding, saving network bandwidth and speeding up
network convergence.
Follow these steps to configure the network type of an interface:
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enter interface view
interface interface-type
interface-number
––
Configure the network
type for the interface as
P2P
isis circuit-type p2p
Optional
By default, The network type of a
VLAN interface is broadcast.
You can only perform this configuration for a broadcast network with only two attached routers.
Configuring IS-IS Routing Information Control
Configuration Prerequisites
Before the configuration, accomplish the following tasks:
z
Configure network layer addresses for interfaces, and make sure adjacent nodes are reachable to
each other at the network layer.
z
Enable IS-IS.