H3C LS-3100-52P-OVS-H3 Operation Manual - page 739
1-9
Follow these steps to configure RIPng zero field check:
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enter RIPng view
ripng [ process-id ]
––
Enable the zero field check
checkzero
Optional
Enabled by default
Configuring the Maximum Number of Equal Cost Routes for Load Balancing
Follow these steps to configure the maximum number of equal cost RIPng routes for load balancing:
To do…
Use the command…
Remarks
Enter system view
system-view
––
Enter RIPng view
ripng [ process-id ]
––
Configure the maximum
number of equal cost RIPng
routes for load balancing
maximum load-balancing
number
Optional
4 by default.
Displaying and Maintaining RIPng
To do…
Use the command…
Remarks
Display configuration
information of a RIPng process
display ripng [ process-id ]
Available in any view
Display routes in the RIPng
database
display ripng process-id database
Available in any view
Display the routing information
of a specified RIPng process
display ripng process-id route
Available in any view
Display RIPng interface
information
display ripng process-id interface
[ interface-type interface-number ]
Available in any view
RIPng Configuration Example
Configure RIPng Basic Functions
Network requirements
As shown in
Figure 1-4
, all switches run RIPng. Configure Switch B to filter the route (3::/64) learnt from
Switch C, which means the route will not be added to the routing table of Switch B, and Switch B will not
forward it to Switch A.