H3C LS-3100-52P-OVS-H3 Operation Manual - page 12
3-3
Features
Description
BPDU Tunneling
BPDU tunneling enables transparently transmission of customer network
BPDU frames over the service provider network. This document
describes:
z
Introduction to BPDU Tunneling
z
Configuring BPDU Transparent Transmission
z
Configuring Destination Multicast MAC Address for BPDU Tunnel
Frames
VLAN Mapping
The VLAN mapping feature maps CVLAN tags to SVLAN tags. This
document describes:
z
Configuring One-to-One VLAN Mapping
z
Configuring Many-to-One VLAN Mapping
z
Configuring Two-to-Two VLAN Mapping
Ethernet OAM
Ethernet OAM is a tool monitoring Layer-2 link status. It helps network
administrators manage their networks effectively. This document
describes:
z
Ethernet OAM overview
z
Configuring Basic Ethernet OAM Functions
z
Configuring Link Monitoring
z
Enabling OAM Loopback Testing
Connectivity Fault
Detection
Connectivity fault detection is an end-to-end, per-VLAN link-layer OAM
mechanism for link connectivity detection, fault verification, and fault
location. This document describes:
z
Connectivity Fault Detection Overview
z
Basic Configuration Tasks
z
Configuring CC on MEPs
z
Configuring LB on MEPs
z
Configuring LT on MEPs
MSTP
MSTP is used to eliminate loops in a LAN. It is compatible with STP and
RSTP. This document describes:
z
Introduction to MSTP
z
Configuring the Root Bridge
z
Configuring Leaf Nodes
z
Performing mCheck
z
Configuring Digest Snooping
z
Configuring No Agreement Check
z
Configuring Protection Functions
RRPP
RRPP is a link layer protocol designed for Ethernet rings. RRPP can
prevent broadcast storms caused by data loops when an Ethernet ring is
healthy, and rapidly restore the communication paths between the nodes
after a link is disconnected on the ring. This document describes:
z
RRPP overview
z
Configuring Master Node
z
Configuring Transit Node
z
Configuring Edge Node
z
Configuring Assistant Edge Node
z
Configuring Ring Group