H3C LS-3100-52P-OVS-H3 Operation Manual - page 584
1-46
To do…
Use the command…
Remarks
Reset OSPF counters
reset ospf [ process-id ] counters[ neighbor
[ interface-type interface-number ] [ router-id ] ]
Reset an OSPF process
reset ospf [ process-id ] process
[ graceful-restart ]
Re-enable OSPF route
redistribution
reset ospf [ process-id ] redistribution
Available in
user view
OSPF Configuration Examples
These examples only cover commands for OSPF configuration.
Configuring OSPF Basic Functions
Network requirements
z
As shown in the following figure, all switches run OSPF. The AS is split into three areas, in which,
Switch A and Switch B act as ABRs to forward routing information between areas.
z
After configuration, all switches can learn routes to every network segment in the AS.
Figure 1-21 Network diagram for OSPF basic configuration
Configuration procedure
1) Configure IP addresses for interfaces (omitted)
2) Configure OSPF basic functions
# Configure Switch A.
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255