H3C LS-3100-52P-OVS-H3 Operation Manual - page 1565
3-2
Table 3-2 Common Telnet configuration
Configuration
Remarks
Configure the command level
available to users logging in to
the VTY user interface
Optional
By default, commands of level 0 are available
to users logging in to a VTY user interface.
Configure the protocols the user
interface supports
Optional
By default, Telnet and SSH protocol are
supported.
VTY user
interface
configuration
Set the command that is
automatically executed when a
user logs into the user interface
Optional
By default, no command is automatically
executed when a user logs into a user
interface.
Define a shortcut key for
aborting tasks
Optional
The default shortcut key combination for
aborting tasks is < Ctrl + C >.
Make terminal services
available
Optional
By default, terminal services are available in
all user interfaces
Set the maximum number of
lines the screen can contain
Optional
By default, the screen can contain up to 24
lines.
Set history command buffer size
Optional
By default, the history command buffer can
contain up to 10 commands.
VTY terminal
configuration
Set the timeout time of a user
interface
Optional
The default timeout time is 10 minutes.
z
The auto-execute command command may cause you unable to perform common configuration
in the user interface, so use it with caution.
z
Before executing the auto-execute command command and save your configuration, make sure
you can log in to the switch in other modes and cancel the configuration.
Telnet Configurations for Different Authentication Modes
Table 3-3
lists Telnet configurations for different authentication modes.
Table 3-3 Telnet configurations for different authentication modes
Authentication
mode
Telnet configuration
Remarks
None
Perform common
configuration
Perform common
Telnet configuration
Optional
Refer to
Table 3-2
.