H3C LS-3100-52P-OVS-H3 Operation Manual - page 749
1-5
To do…
Use the command…
Remarks
Enter system view
system-view —
Enable an OSPFv3 process
and enter its view
ospfv3 [ process-id ]
Required
By default, no OSPFv3 process
is enabled.
Specify a router ID
router-id router-id
Required
Enter interface view
interface interface-type
interface-number
—
Enable an OSPFv3 process on
the interface
ospfv3 process-id area area-id
[ instance instance-id ]
Required
Not enabled by default
Configuring OSPFv3 Area Parameters
The stub area and virtual link features of OSPFv3 are the same as OSPFv2.
Splitting an OSPFv3 AS into multiple areas reduces the number of LSAs and extends OSPFv3
applications. For those non-backbone areas residing on the AS boundary, you can configure them as
stub areas to further reduce the size of routing tables and the number of LSAs.
Non-backbone areas exchange routing information via the backbone area. Therefore, the backbone
and non-backbone areas, including the backbone itself must be contiguous. In practice, necessary
physical links may not be available for such connectivity. You can configure virtual links to address the
problem.
Prerequisites
z
Enable IPv6 packet forwarding
z
Configure OSPFv3 basic functions
Configuring an OSPFv3 Stub Area
Follow these steps to configure an OSPFv3 stub area:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter OSPFv3 view
ospfv3 [ process-id ]
—
Enter OSPFv3 area view
area area-id
—
Configure the area as a stub area stub [ no-summary ]
Required
Not configured by default
Specify a cost for the default route
advertised to the stub area
default-cost value
Optional
Defaults to 1