H3C LS-3100-52P-OVS-H3 Operation Manual - page 1577
3-14
Step 1: Configure the user name and password for Telnet on the switch operating as the Telnet server.
Refer to section
Telnet Configuration with Authentication Mode Being None
”, section
Telnet
Configuration with Authentication Mode Being Password
, and
Telnet Configuration with Authentication
Mode Being Scheme
for details. By default, Telnet users need to pass the password authentication to
login.
Step 2: Telnet to the switch operating as the Telnet client.
Step 3: Execute the following command on the switch operating as the Telnet client:
Where xxxx is the IP address or the host name of the switch operating as the Telnet server. You can use
the ip host to assign a host name to a switch.
Step 4: Enter the password. If the password is correct, the CLI prompt (such as
VTY user interfaces of the switch are in use, you will fail to establish the connection and receive the
message that says “All user interfaces are used, please try later!”.
Step 5: After successfully Telnetting to the switch, you can configure the switch or display the
information about the switch by executing corresponding commands. You can also type ? at any time for
help. Refer to the following chapters for the information about the commands.