H3C LS-3100-52P-OVS-H3 Operation Manual - page 277
1-41
Figure 1-10 Network diagram for MSTP configuration
Device A
Device B
Device D
Device C
Permit:all VLAN
Permit:VLAN 20,40
Permit:
VLAN 10,20
Permit:
VLAN 10,20
Permit:
VLAN 20,30
Permit:
VLAN 20,30
“Permit:“ beside each link in the figure is followed by the VLANs the packets of which are permitted to
pass this link.
Configuration procedure
1) Configuration on Device A
# Enter MST region view.
[DeviceA] stp region-configuration
# Configure the region name, VLAN-to-MSTI mappings and revision level of the MST region.
[DeviceA-mst-region] region-name example
[DeviceA-mst-region] instance 1 vlan 10
[DeviceA-mst-region] instance 3 vlan 30
[DeviceA-mst-region] instance 4 vlan 40
[DeviceA-mst-region] revision-level 0
# Activate MST region configuration manually.
[DeviceA-mst-region] active region-configuration
[DeviceA-mst-region] quit
# Define Device A as the root bridge of MSTI 1.
[DeviceA] stp instance 1 root primary
# Enable MSTP globally.
[DeviceA] stp enable
# View the MST region configuration information that has taken effect.
[DeviceA] display stp region-configuration
Oper configuration
Format selector :0
Region name :example
Revision level :0
Instance Vlans Mapped