H3C LS-3100-52P-OVS-H3 Operation Manual - page 57
1-5
The system sets the load sharing mode of an aggregation group as follows:
z
When hardware resources are available, a link aggregation group with at least two selected ports
operates in load sharing mode. The load sharing mode of a link aggregation group with only one
selected port is non-load sharing mode.
z
After hardware resources become depleted (a number of 128 link aggregation groups have been
created in the system), all the link aggregation groups operate in non-load sharing mode.
z
After you remove all ports but one selected port from a load-sharing aggregation group, the
aggregation group remains to be a load sharing group.
z
A load-sharing aggregation group contains at least one selected port while a non-load-sharing
aggregation group can only have one selected port at most.
z
After hardware resources become depleted, all new link aggregation groups operate in non-load
sharing mode. They will not perform load sharing even after resources become available again for
example after some aggregation groups are removed. To have them perform load sharing, you can
re-enable their corresponding aggregation interfaces by shutting down and then bringing up the
interfaces.
Link Aggregation Configuration Task List
Complete the following tasks to configure link aggregation:
Task
Remarks
Configuring a Static Aggregation Group
Configuring an
Aggregation Group
Configuring a Dynamic Aggregation Group
Required
Perform either of the tasks
Configuring the Description of an Aggregate
Interface
Optional
Enabling LinkUp/LinkDown Trap Generation
for an Aggregate Interface
Optional
Configuring an
Aggregate Interface
Shutting Down an Aggregate Interface
Optional
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Optional