H3C LS-3100-52P-OVS-H3 Operation Manual - page 1673
1-3
Figure 1-2 MIB tree
A
2
6
1
5
2
1
1
2
1
B
SNMP Configuration
As configurations for SNMPv3 differ substantially from those of SNMPv1 and SNMPv2c, their SNMP
functionalities is introduced separately below.
Follow these steps to configure SNMPv3:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable SNMP agent
snmp-agent
Optional
Disabled by default
You can enable SNMP agent
through this command or any
commands that begin with
snmp-agent.
Configure SNMP agent system
information
snmp-agent sys-info
{ contact sys-contact |
location sys-location | version
{ all | { v1 | v2c | v3 }* } }
Optional
The defaults are as follows:
Hangzhou H3C Tech. Co., Ltd.
for contact,
Hangzhou China for location,
and SNMP v3 for the version.
Configure an SNMP agent
group
snmp-agent group v3
group-name[ authentication |
privacy ] [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Required
Convert the user-defined plain
text password to a cipher text
password
snmp-agent
calculate-password
plain-password mode { md5 |
sha | 3desmd5 | 3dessha }
{ local-engineid |
specified-engineid engineid }
Optional
Add a new user to an SNMP
agent group
snmp-agent usm-user v3
user-name group-name
[ [ cipher ]
authentication-mode { md5 |
sha } auth-password
[ privacy-mode { 3des |
aes128 | des56 }
priv-password ] ] [ acl
acl-number ]
Required
If the cipher keyword is
specified, the arguments
auth-password and
priv-password are considered
as cipher text password.