H3C LS-3100-52P-OVS-H3 Operation Manual - page 794
1-17
Configuring IPv6 BGP Community
Advertise community attribute to an IPv6 peer/peer group
Follow these steps to advertise community attribute to an IPv6 peer/peer group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 address family view
ipv6-family
—
Advertise community attribute
to an IPv6 peer/peer group
peer { ipv6-group-name |
ipv6-address }
advertise-community
Required
Not advertised by default.
Advertise extended community
attribute to an IPv6 peer/peer
group
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
Required
Not advertised by default.
Apply a routing policy to routes advertised to a peer/peer group
Follow these steps to apply a routing policy to routes advertised to a peer/peer group:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 address family view
ipv6-family
—
Apply a routing policy to routes
advertised to an IPv6 peer/peer
group
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
Required
Not applied by default.
z
When configuring IPv6 BGP community, you need to configure a routing policy to define the
community attribute, and apply the routing policy to route advertisement.
z
For routing policy configuration, refer to Routing Policy Configuration in the IP Routing Volume.
Configuring an IPv6 BGP Route Reflector
Follow these steps to configure an IPv6 BGP route reflector:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter BGP view
bgp as-number
—
Enter IPv6 address family view
ipv6-family
—