D-Link DES-3250TG Command Line Interface Reference Manual - page 127
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
127
config syslog host
Purpose
Used to configure the syslog protocol to send
system log data to a remote host.
Syntax
config syslog host [all|
[informational|warning|all]|
facility[local0|local1|local2|local3|
local4|local5|local6|local7]|udp_port
state[enabled|disabled]
Description
The config syslog host command is used to
configure the syslog protocol to send system log
information to a remote host.
Parameters
all
− Specifies that the command will be applied
to all hosts.
− Specifies that the command will
be applied to an index of hosts. There are four
available indexes, numbered 1 through 4.
severity
− Severity level indicator. These are
described in the following:
Bold font indicates that the corresponding
severity level is currently supported on the
switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions