D-Link DES-3250TG Command Line Interface Reference Manual - page 47
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
47
reset
Purpose
Used to reset the switch to the factory default
settings.
Syntax
reset {[config|system]}
Description
This command is used to restore the switch’s
configuration to the default settings assigned
from the factory.
Parameters
config
− If config is specified, all of the factory
default settings are restored on the switch
except for the IP address, user accounts, and
the switch history log.
system
− If system is specified all of the factory
default settings are restored on the switch.
If no parameter specified, the switch’s current IP
address, user accounts, and switch history log
are retained. All other parameters are restored
to their factory default settings.
Restrictions Only
administrator-level users can issue this
command.
Example Usage:
To restore all of the switch’s parameters to their default values:
local>reset config
Command: reset config
Success.
local>