D-Link DES-3250TG Command Line Interface Reference Manual - page 222
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
222
config lacp_port
Purpose
Used to configure the Link Aggregation Control
Protocol (LACP) on a per-port basis.
Syntax
config lacp_ports
[active|passive]
Description
Link Aggregation Control Protocol (LACP) is
part of an IEEE specification (802.3ad) that
allows you to bundle several physical ports
together to form a single logical channel. LACP
allows a switch to negotiate an automatic
bundle by sending LACP packets to the peer.
Parameters
−
mode
− active passive
Restrictions Only
administrator-level users can issue this
command.
Example usage:
To configure ports 1 through 5 as being LACP active:
local>config lacp_port 1-5 mode active
Command: config lacp_port 1-5 mode active
local>