D-Link DES-3250TG Command Line Interface Reference Manual - page 260
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
260
config 802.1x init
Purpose
Used to initialize the 802.1x functions on a
range of ports.
Syntax
config 802.1x init port_based ports
[
[
Description
The config 802.1x initcommand is used to
immediately initialize the 802.1x functions on a
range of ports.
Parameters
port_based|mac_based ports
− The switch
allows you to configure 802.1x by either port or
MAC address.
− Specifies a range of ports. The port
list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example, 3
would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port
4
− in numerical order.
all
− Specifies all of the ports on the switch.
Restrictions Only
administrator-level users can issue this
command.