D-Link DES-3250TG Command Line Interface Reference Manual - page 136
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
136
config stp
Purpose
Used to setup STP and RSTP on the switch.
Syntax
config stp {maxage
30>|priority
[enabled|disabled]| txholdcount
10>| version[rstp|stp]}
Description
This command is used to setup the Spanning
Tree Protocol (STP) for the entire switch.
Parameters
maxage
− The maximum amount
of time (in seconds) that the switch will wait to
receive a BPDU packet before reconfiguring
STP. The default is 20 seconds.
hellotime
− The time interval
between transmission of configuration
messages by the root device. The default is 2
seconds.
forwarddelay
− The maximum
amount of time (in seconds) that the root device
will wait before changing states. The default is
15 seconds.
priority
− A numerical value
between 0 and 61440 that is used in
determining the root device, root port, and
designated port. The device with the highest
priority becomes the root device. The lower the
numerical value, the higher the priority. The
default is 32,768.
fbpdu [enabled|disabled]
− Allows the
forwarding of STP BPDU packets from other
network devices when STP is disabled on the
switch. The default is enabled.
txholdcount