D-Link DES-3250TG Command Line Interface Reference Manual - page 255
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
255
config 802.1x capability
Purpose
Used to configure the 802.1x capability of a
range of ports on the switch.
Syntax
config 802.1x capability ports [
[authenticator|none]
Description
The config 802.1xcommand has two
capabilities that can be set for each port:
Authenticator and None.
Parameters
− Specifies a range of ports. The port
list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example, 3
would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port
4
− in numerical order.
all
− Specifies all of the ports on the switch.
authenticator
− A user must pass the
authentication process to gain access to the
network.
none
− The port is not controlled by the 802.1x
functions.
Restrictions Only
administrator-level users can issue this
command.