D-Link DES-3250TG Command Line Interface Reference Manual - page 277
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
277
create access_profile
Purpose
Used to create an access profile on the switch
and to define which parts of each incoming
frame’s header the switch will examine. Masks
can be entered that will be combined with the
values the switch finds in the specified frame
header fields. Specific values for the rules are
entered using the config access_profile
command, below.
Syntax
create access_profile [ethernet
{vlan|source_mac
|802.1p|ethernet_type}|ip
{vlan|source_ip_mask
{type}|tcp {src_port_mask
0xffff>|dst_port_mask
{src_port_mask
0xfff>|dst_port_mask
0xffff>}|protocol_id {user_mask
0xffffffff>}]}]{[permit|deny]|profile_id
1-255>}
Description
The create access_profilecommand is used to
create an access profile on the switch and to
define which parts of each incoming frame’s
header the switch will examine. Masks can be
entered that will be combined with the values
the switch finds in the specified frame header
fields. Specific values for the rules are entered
using the config access_profile command,
below.
Parameters
ethernet
− Specifies that the switch will examine
the layer 2 part of each packet header.