D-Link DES-3250TG Command Line Interface Reference Manual - page 130
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
130
config syslog host
be sent to the remote host. This corresponds to
number 19 from the list above.
local4
− Specifies that local use 4 messages will
be sent to the remote host. This corresponds to
number 20 from the list above.
local5
− Specifies that local use 5 messages will
be sent to the remote host. This corresponds to
number 21 from the list above.
local6
− Specifies that local use 6 messages will
be sent to the remote host. This corresponds to
number 22 from the list above.
local7
− Specifies that local use 7 messages will
be sent to the remote host. This corresponds to
number 23 from the list above.
udp_port
− Specifies the
UDP port number that the syslog protocol will
use to send messages to the remote host.
ipaddress
− Specifies the IP address
of the remote host where syslog messages will
be sent.
state [enabled|disabled]
− Allows the sending of
syslog messages to the remote host, specified
above, to be enabled and disabled.
Restrictions Only
administrator-level users can issue this
command.