D-Link DES-3250TG Command Line Interface Reference Manual - page 293
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
293
config sntp
Purpose
Used to configure SNTP on the switch.
Syntax
config sntp
Description
This command is used to configure SNTP on
the switch.
Parameters
primary
− This is the primary server the SNTP
information will be taken from.
− The IP address of the primary
server.
secondary
− This is the secondary server the
SNTP information will be taken from in the event
the primary server is unavailable.
− The IP address for the secondary
server.
poll-interval
− This is the time the SNTP
information will be polled.
− The polling interval ranges
from 30 to 99,999 seconds.
Restrictions Only
administrator-level users can issue this
command.
Example Usage:
To configure SNTP for the primary server for a switch.
local>config sntp primary 10.24.22.5
Success.
Command: config sntp primary 10.24.22.5
local>