D-Link DES-3250TG Command Line Interface Reference Manual - page 264
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
264
config 802.1x auth_mode
Purpose
Used to configure the 802.1x authentication
mode feature of the switch.
Syntax
config 802.1x reauth port_based ports
[
[
Description
The config 802.1x authentication mode
command is used to enable either the port-
based or MAC-based 802.1x authentication
feature on the switch.
Parameters
port_based|mac_based ports
− The switch
allows you to authenticate 802.1x by either port
or MAC address.
− Specifies a range of ports. The port
list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example, 3
would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port
4
− in numerical order.
all
− Specifies all of the ports on the switch.
Restrictions Only
administrator-level users can issue this
command.