D-Link DES-3250TG Command Line Interface Reference Manual - page 266
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
266
config radius add
Purpose
Used to configure the settings the switch will
use to communicate with a Radius server.
Syntax
config radius add
[default|{auth_port
acct_port
Description
The config radius add command is used to
configure the settings the switch will use to
communicate with a Radius server.
Parameters
− Assigns a number to the
current set of Radius server settings. Up to
three groups of Radius server settings can be
entered on the switch.
− The IP address of the Radius
server.
key
− Specifies that a password and encryption
key will be used between the switch and the
Radius server.
− The shared-secret key used by
the Radius server and the switch. Up to 32
characters can be used.
default
− Returns all of the ports in the range to
their default Radius settings.
auth_port
− The UDP port
number for authentication requests. The default
is 1812.
acct_port
− The UDP port
number for accounting requests. The default is
1813.
Restrictions Only
administrator-level users can issue this
command.