D-Link DES-3250TG Command Line Interface Reference Manual - page 53
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
53
show ports
Purpose
Used to display the current configuration of a
range of ports.
Syntax
show ports {
Description
This command is used to display the current
configuration of a range of ports.
Parameters
all
− Displays all ports on the switch.
− Specifies a range of ports to be
configured. The port list is specified by listing
the beginning port number and the highest port
number of the range. The beginning and end of
the port list range are separated by a dash. For
example, 3 would specify port 3. 4 specifies port
4. 3-4specifies all of the ports between port 3
and port 4
− in numerical order.
Restrictions none.
Example Usage:
To display the configuration of the ports 1-7:
local>show ports 1-7
Command: show ports 1-7
Port Port Settings Connection Address
State Speed|Duplex Speed|Duplex Learning
---- -------- --------------------- --------------------- -----------
1 Enabled Auto Link Down Enabled
2 Enabled Auto Link Down Enabled