D-Link DES-3250TG Command Line Interface Reference Manual - page 146
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
146
show stp ports
Purpose
Used to display the switch’s current per-port
group STP configuration.
Syntax
show stp ports
Description
This command displays the switch’s current per-
port group STP configuration.
Parameters
− Specifies a range of ports to be
configured. The port list is specified by listing
the lowest switch number and the beginning
port number on that switch, separated by a
colon. Then highest switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 3 would
specify port 3. 4 specifies switch number 2, port
4. 3-4specifies all of the ports between port 3
and port 4
− in numerical order.
Restrictions None
Example Usage:
To display the STP state of ports 1-9:
local>show stp ports 1-9
Command: show stp ports 1-9
Port Designated Bridge State Cost Pri Edge P2P Status Role
------ -------------------------- -------- ----------- ----- ------ ----- --------- ------------
1 8000|000104031001 Yes *200000 128 No Yes Forwarding Designated
2 N|A Yes *200000 128 No Yes Disabled Disabled