D-Link DES-3250TG Command Line Interface Reference Manual - page 223
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
223
show lacp_ports
Purpose
Used to display the current status of LACP on a
per-port basis.
Syntax
show lacp_port {
Description
Displays the current status of LACP on a per-
port basis.
Parameters
− A range of ports for which you want
ingress checking. The port list is specified by
listing the beginning port number and the
highest port number of the range. The beginning
and end of the port list range are separated by a
dash. For example, 3 would specify port 3. 4
specifies port 4. 3-4specifies all of the ports
between port 3 and port 4
− in numerical order.
Restrictions Only
administrator-level users can issue this
command.
Example usage:
To display the LACP status of ports 1 through 5:
local>show lacp_port 1-5
Command: show lacp_port 1-5
Port Activity
------ ---------
1 Active
2 Active
3 Active
4 Passive
5 Passive
local>