D-Link DES-3250TG Command Line Interface Reference Manual - page 230
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
230
config igmp_snooping
Purpose
Used to configure IGMP snooping on the switch.
Syntax
config igmp_snooping [
{host_timeout
[enabled|disabled]}
Description
This command allows you to configure IGMP
snooping on the switch.
Parameters
− The name of the VLAN for
which IGMP snooping is to be configured.
host_timeout
− Specifies the maximum
amount of time a host can be a member of a
multicast group without the switch receiving a
host membership report. The default is 260
seconds.
route_timeout
− Specifies the maximum
amount of time a route will remain in the
switch’s can be a member of a multicast group
without the switch receiving a host membership
report. The default is 260 seconds.
leave_timer
− Leave timer. The default is
2 seconds.
state [enabled|disabled]
− Allows you to enable
or disable IGMP snooping for the specified
VLAN.
Restrictions Only
administrator-level users can issue this
command.