D-Link DES-3250TG Command Line Interface Reference Manual - page 41
Manual is about: Layer 2 Switch
of
322
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
41
enable telnet
Purpose
Used to enable communication with and
management of the switch using the Telnet
protocol.
Syntax
enable telnet
Description
This command is used to enable the Telnet
protocol on the switch. The user can specify the
TCP or UDP port number the switch will use to
listen for Telnet requests.
Parameters
− The TCP port number.
TCP ports are numbered between 1 and 65535.
The “well-known” TCP port for the Telnet
protocol is 23.
Restrictions Only
administrator-level users can issue this
command.
Example Usage:
To enable Telnet and configure port number:
local>enable telnet 23
Command: enable telnet 23
Success.
local>