D-Link DES-3250TG Command Line Interface Reference Manual - page 200
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
200
config gvrp
Purpose
Used to configure GVRP on the switch.
Syntax
config gvrp [
[enabled|disabled]|ingress_checking
[enabled|disabled] pvid
Description
This command is used to configure the Group
VLAN Registration Protocol on the switch. You
can configure ingress checking and the sending
and receiving of GVRP information.
Parameters
− A range of ports for which you want
ingress checking. The port list is specified by
listing the beginning port number and the
highest port number of the range. The beginning
and end of the port list range are separated by a
dash. For example, 3 would specify port 3. 4
specifies port 4. 3-4specifies all of the ports
between port 3 and port 4
− in numerical order.
all
− Specifies all of the ports on the switch.
state [enabled|disabled]
− Enabled or disables
GVRP for the ports specified in the port list.
ingress_checking [enabled|disabled]
− Enables
or disables ingress checking for the specified
port list.
pvid
− This is the VLAN ID
(VID) of the VLAN for which you want to
configure GVRP.
Restrictions Only
administrator-level users can issue this
command.