D-Link DES-3250TG Command Line Interface Reference Manual - page 249
DES-3250TG Layer 2 Fast Ethernet Switch User’s Guide
249
show 802.1x auth_configuration
Purpose
Used to display the current authenticated
configuration of the 802.1x server on the switch.
Syntax
show 802.1x auth_configuration {ports
Description
The show 802.1xauth_configurationcommand
is used to display the current authenticated
configuration of the 802.1x Port-based Network
Access Control server application on the switch.
Parameters
ports
− Specifies a range of ports. The
port list is specified by listing the lowest switch
number and the beginning port number on that
switch, separated by a colon. Then highest
switch number, and the highest port number of
the range (also separated by a colon) are
specified. The beginning and end of the port list
range are separated by a dash. For example, 3
would specify port 3. 4 specifies port 4. 3-4
specifies all of the ports between port 3 and port
4
− in numerical order.
The following details what is displayed:
802.1x Enabled|Disabled
− Shows the current
status of 802.1x functions on the switch.
Authentication Mode: Port_based |Mac_based
|None – Shows the current authentication mode.
Authentication Protocol: Radius_Eap
− Shows
the authentication protocol suite in use between
the switch and a Radius server.
Port number
− Shows the physical port number
on the switch.
Capability: Authenticator|None
− Shows the
capability of 802.1x functions on the port
number displayed above. There are four 802.1x
capabilities that can be set on the switch: