Qlogic 3200 Series User Manual - -Fs
6–Fibre Channel Noninteractive Commands
-fs (Driver Parameters)
6-14
SN0054667-00 G
To show the driver settings, issue the following command:
# qaucli -pr fc -fg (<hba instance> | <hba wwpn>) (view | info)
Where:
-fs
(Driver Parameters)
To configure the driver settings, issue the following command:
# qaucli -pr fc -fs (<hba instance> | <hba wwpn>) {(<param name> |
<param alias>) <param value>}
Where:
The pairs <param name> <param value> and <param alias> <param
value> can be repeated to set multiple parameters in a single command.
lists the driver configuration parameter names and aliases.
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
hba instance = Adapter instance number of an adapter port (use the
-g command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameters
param alias = Alias of the parameters
param value = New value of the parameters
Table 6-4. Driver Settings Parameters
Description
Parameter Name
Alias
alias>
Value
a
value>
a
0 = Disabled, 1 = Enabled
Persistently bound target(s) only
PersistentOnly
PO
0, 1
Present persistently bound tar-
get(s) plus any new target(s) with
driver default
PersistentPlusNew
PN
0, 1
Present targets with driver default
NewOnly
b
b
Driver parameter NewOnly (NO) is supported only with the failover driver.
NO
0, 1
Bind devices by WWPN
BindWWPN
BW
0, 1
Bind devices by port ID
BindPortID
BP
0, 1