Qlogic 3200 Series User Manual - page 64
5–NIC Noninteractive Commands
-flashsupport
5-6
SN0054667-00 G
Where <flash_file> is the name of the Flash file that will be used to
update the adapter.
-i
option:
To set the adapter interface, issue the following command:
> qaucli -pr nic -flashsupport -i --interface <interface_id>
Where interface_id is an interface ID value displayed by the -vi
switch.
-a
option:
To burn or update all Flash regions for the interface specified by the previous
-i command, issue the following command:
> qaucli -pr nic -flashsupport -a --all [ql_romimage]
Where
<ql_romimage>
is the name of the name of the Flash file that will be
used to update the adapter. If the file is not specified, the default file (named
ql_romimage) in the working directory is used.
-info
option:
To display information for the interface specified by the previous -i
command (or all discovered adapters when the interface not specified),
issue the following command:
> qaucli -pr nic -flashsupport -info --information
-w0
option:
To disable Wake on LAN (WoL) for the interface specified by the previous
-i command, issue the following command:
> qaucli -pr nic -flashsupport -w0 --wol-off
-w1
option:
To enable WoL for the interface specified by the previous -i command,
issue the following command:
> qaucli -pr nic -flashsupport -w1 --wol-on
NOTE
You must use the -i command to specify the adapter interface before
using any of the following options: -a, -info, -w0, -w1, -p0, or -p1.