Qlogic 3200 Series User Manual - page 144
7–iSCSI Noninteractive Commands
-n (Configure iSCSI Settings)
7-16
SN0054667-00 G
-n
(Configure iSCSI Settings)
To set the adapter iSCSI parameters for single-port adapters, issue the -n
command as follows:
-n <hba_port_inst> <config_name|config_alias>
[
After you issue this command, the adapter is reset.
You can repeat the (<config_name>|<config_alias> <value>) parameters
for as many parameters as you need to configure.
lists these
parameters and their ranges of values.
Table 7-3. Adapter Parameters
Configuration Name
Configuration Alias
Value
Add Firmware Options
AFW_AutoConnect
AFWAC
on or off
AFW_Device_Timeout
AFWDT
on or off
AFW_Delayed_Ack
AFWDACK
on or off
ExeThrottle
ET
0–32767
FirstBurstLen
FB
0–32767
IP Options
IP_ARP_Redirect
IPARP
on or off
IP_Address
IPAD
IP address format
IP_Subnet_Mask
IPSM
IP address format
IP_Gateway
IPGW
IP address format
iSCSI Options
Force_Negotiate_Main_iSCSI_Keys
—
—
iSCSI_Alias
IALS
on or off
iSCSI_Data_Digests
IDD
on or off
iSCSI_Discovery_Logout
ID
on or off
iSCSI_Header_Digests
IHD
on or off
iSCSI_Immediate_Data
IID
on or off
iSCSI_Initial_R2T
IIR2T
on or off