Qlogic 3200 Series User Manual - -Intloopback
5–NIC Noninteractive Commands
-intloopback
SN0054667-00 G
5-9
-intloopback
To configure loopback test parameters before you run the test, issue the
intloopback command as follows:
> qaucli -pr nic -intloopback <cna_port_inst> <tests_num>
<on_error>
Where
and 65,535) and
encountered during the test (0 = ignore the error; 1 = abort the test).
-iset
(Display Configured Port Settings)
To view configured port settings, issue the -iset command as follows:
> qaucli -pr nic -iset [cna_port_inst]
For example:
> qaucli -pr nic -iset 1
=== Configured Port Settings for 1. CNA Port Index ===
Header_Data_Split_Enable : off
IPv4_Large_Send_Offload_v1_Enable : on
IPv4_Large_Send_Offload_v2_Enable : on
IPv6_Large_Send_Offload_v2_Enable : on
IPv4_TCP_Checksum_Offload_Enable : RxTx
IPv6_TCP_Checksum_Offload_Enable : RxTx
IPv4_UDP_Checksum_Offload_Enable : RxTx
IPv6_UDP_Checksum_Offload_Enable : RxTx
Jumbo_Frames_MTU_9000_Enable_Rx : off
Jumbo_Frames_MTU_9000_Enable_Tx : off
LOCAL_Administered_Address_MAC : 00:c0:dd:12:0f:f4
MAC_Address_Alias : paul
Receive_Side_Scaling_Enable : on
Receive_Ring_Size : 0
Transmit_Ring_Size : 0
PromiscuousModeEnabled : off
NOTE
An external loopback test requires the installation of a loopback plug in the
port SFP.
NOTE
For Linux and Solaris, the configured port settings and their values are
different from what is shown in the following example.