Qlogic 3200 Series User Manual - -Fwdump
6–Fibre Channel Noninteractive Commands
-fwdump (Firmware Dump)
SN0054667-00 G
6-15
The following restrictions apply:
Under Solaris, the driver configuration feature is disabled if you are using the
driver from the OS installation CDs (QLC driver).
Under Linux, this feature is disabled if you are using the input/output control
(IOCTL) driver.
Under Mac OS
®
, the BindWWPN and BindPortID parameters are not
changeable; Mac OS supports only the BindWWPN parameter.
-fwdump
(Firmware Dump)
To save the current adapter port firmware dump to a file, issue the following
command:
# qaucli -pr fc -fwdump (<hba instance> | <hba wwpn>) <file name>
Where:
-g
(Generate Reports)
To run a report containing host information and more, issue the -g command.
-gs
(Configure Parameters [FC Port Statistics])
To configure the adapter statistics, issue the -gs command as follows:
# qaucli -pr fc -gs
(
<hba instance> | <hba wwpn>) [(<param name> |
<param alias>) <param value>]
Where:
hba instance = Adapter instance number of an adapter port (use the
-g command to find)
hba wwpn = World wide port name of the adapter
file name = Name of the file to save the firmware dump to
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameter
param alias = Alias of the parameter
param value = New value of the parameter