Qlogic 3200 Series User Manual - -Pdt
7–iSCSI Noninteractive Commands
-pdt (Disable a Target)
7-20
SN0054667-00 G
For information on secondary boot code, see
“-sbootcode (Set Secondary Boot
Target Information)” on page 7-24
.
-pdt
(Disable a Target)
To disable a target, issue the -pdt command as follows:
-pdt <hba_port_inst> <targetId>
-pet
(Enable a Target)
To enable a target, issue the -pet command as follows:
-pet <hba_port_inst> <targetId>
-pinfo
(CNA Port Information—iSCSI)
To view port information for the specified adapter, issue the -pinfo command
as follows:
-pinfo <hba_port_inst>
-ping
(Ping Target)
To ping the target device, issue the -ping command as follows:
-ping <hba_port_inst> <IP Address> <Ping Count> <Packet size>
<IPv6 source address>
The following provides the IPv6 source address
values:
Where:
-ps
To view persistent targets for the adapter port, issue the -ps command as
follows:
-ps <hba_port_inst> [target_ID]
0 = Do not care
1 = Local link
2 = Address 0
3 = Address 1
hba_port_inst = The adapter port that sends the ping
IP Address = The IP address to ping
Ping Count = The number of ping packets you want (1–[2
31
]).
Packet Size = The size of the ping packet 0–64kB
IPv6 Source Address = Origin device