Qlogic 3200 Series User Manual - Refresh
10–Fibre Channel Interactive Commands
Refresh
10-54
SN0054667-00 G
General keyboard shortcuts:
R - Reset current
C - Refresh current
T - Refresh total
ENTER - Cancel the current task
-------------------------------------------
Port Name Link Syncs Signal Invalid Seq Proto Invalid
Failure Loss Loss CRC Error Trans Word
------------------------------- -------- ------ ------ ------- --------- ----------
Port(21-00-00-1B-32-17-F9-C4) 0 0 0 0 0 0
-----------------------------------------------------------------------------------
Refresh
6. Refresh
From the main menu, select the Refresh option to refresh (reload) the adapters
and adapter port indexes. For example:
Scanning for QLogic adapters, please wait...
Using config file: C:\Program Files\...\iscli.cfg
Using config file: C:\Program Files\...\netscli.cfg
Loading: 1. CNA ... adapters, please wait...
Loading: 1. CNA Port index : 1 ...
Loading: 1. CNA Port index : 2 ...
Refreshing interfaces ... Please wait ......
Scanning for QLogic adapters, please wait...
Hit
When you run QConvergeConsole CLI, the CLI collects all relevant information,
including the number of available ports and the state of each one. Between the
time you start QConvergeConsole CLI and the time you perform a specific action
or request additional information, changes may have occurred to the port state,
network state, or firmware parameters. To ensure that you are viewing the most
current information, you should perform a Refresh. (In some cases,
QConvergeConsole CLI automatically refreshes the information before or after
specific commands.)