Qlogic 3200 Series User Manual - -Acb
7–iSCSI Noninteractive Commands
-acb
SN0054667-00 G
7-5
-acb
To inquire whether the address control block (ACB) firmware functions are
supported, issue the -acb command. In general, up-to-date firmware and driver
are required for ACB to be supported.
-addchap
(Add a CHAP Entry)
To add a CHAP entry to the persistent CHAP table, issue the -addchap
command as follows:
-addchap [-BIDI] <hba_port_inst> <CHAP Name> <CHAP Secret>
The optional parameter -BIDI
shows that the CHAP entry is bidirectional (BIDI).
When this parameter is not specified (default), the CHAP entry is local. Issuing
this command resets the adapter.
-arp
(Display ARP Table)
The address resolution protocol (ARP) cache keeps a record of host port
connections with other hardware (such as targets) on the network. The IP address
and MAC address pairs are dynamic entries that are removed after 10 minutes. To
view the ARP table, issue the -arp command as follows:
-arp
-b
(Save Changes and Reset HBA)
To reset the specified adapter after making configuration changes, issue the -b
command as follows:
-b
-binfo
(Display BIOS/UEFI Information)
To display the boot code settings for the specified adapter port, issue the -binfo
command as follows:
-binfo
-bootcode
Boot code (the bootable code image) allows system boot from an iSCSI drive. The
-bootcode command updates the boot code image, which should be done
when QLogic releases a new boot code with bug fixes or enhancements. At the
prompt, type the name of the file containing the boot code image to upload to the
adapter.
NOTE
Issuing this command resets both ports (0 and 1) on two-port adapters.