Qlogic 3200 Series User Manual - -Sp
6–Fibre Channel Noninteractive Commands
-s
6-36
SN0054667-00 G
Where:
To save the adapter parameters to a file, issue the following command:
# qaucli -pr fc -r (<hba instance> | <hba wwpn>) save <File Name>
Where:
-s
In noninteractive mode, the system shows result and status messages generated by
QConvergeConsole CLI (by default) unless suppressed by silent mode. You can
combine the -s option with the -o option (see
) so the output is
saved in a file and does not appear in the CLI. For example:
# qaucli -pr fc -I all -s -o output.txt
-sp
To update the adapter firmware serializer/deserializer (SerDes) table from a file, issue
the following command:
# qaucli -pr fc -sp <hba instance> | <hba wwpn> <file name>
To save the adapter firmware SerDes table to a file, issue the following command:
# qaucli -pr fc -sp
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
all = All adapter ports in the system are updated with the new
adapter parameters
File Name = File name or a path to a file that contains the updated adapter
parameters
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
hba parameters file
name
= File name or a path to a file to save the adapter parameters
NOTE
The -s option is valid only in noninteractive mode.
You can use this option with all noninteractive mode options that have a
corresponding interactive mode option (see
). This
option must be the first or last command in the command line.