Qlogic 3200 Series User Manual - -Ch
7–iSCSI Noninteractive Commands
-c (CNA Port Information—iSCSI)
7-6
SN0054667-00 G
To update the boot code image, issue the -bootcode command as follows:
-bootcode
-c
(CNA Port Information—iSCSI)
To view the configured settings for the port, issue the -c command as follows:
-c [hba_port_inst]
When you specify a port instance, information for only that adapter is shown.
When you do not specify a port instance, information for all adapter ports in the
system is shown.
-ch
(CNA Adapter Information—iSCSI)
To display the adapter’s configured settings, issue the -ch command as follows:
-ch [hba_port_inst]
When you specify a port instance, information for only that adapter is shown.
When you do not specify a port instance, information for all adapter ports in the
system is shown.
-chapmap
(Display Targets Using CHAP Entries)
To display the map of targets to CHAP table entries, issue the -chapmap
command as follows:
-chapmap
-cpbootcode
(Clear Primary Boot Target Information)
To clear the primary boot target and LUN, issue the -cpbootcode command as
follows:
-cpbootcode
-csbootcode
(Clear Secondary Boot Target Information)
To clear the secondary boot target and LUN, issue the -csbootcode command
as follows:
-csbootcode
NOTE
This command is not active for the PPC.