Qlogic 3200 Series User Manual - -Rdf
7–iSCSI Noninteractive Commands
-rdf
7-22
SN0054667-00 G
-rdf
To restore the specified adapter port’s firmware values to the factory default
values, issue the -rdf command:
-rdf <hba_port_inst>
Issuing this command resets the adapter.
-rdh
(Port Restore Factory Defaults)
Type the following command to restore the specified adapter port’s settings to
their factory defaults:
-rdh <hba_port_inst> [A] [F N I T C V]
Where:
If you want to restore all areas of the adapter port, either use the A parameter or
use no parameter. Otherwise, specify which areas to restore. For example, the
following command restores the firmware and NVRAM to the factory defaults:
-rdh <hba_port_inst> F N
hba_port_inst = Adapter port whose factory settings you want to restore.
A = Restore the factory settings for the entire adapter (firmware
parameters, network parameters, iSCSI name, targets, CHAP
table, NVARAM, and Internet Protocol security [IPsec]).
Issuing this command resets the adapter. If you use this option,
no others are necessary.
F = Restore firmware parameters to the factory default values.
Issuing this command resets the adapter.
N = Restore network parameters to the factory default values.
Issuing this command resets the adapter.
I = Restore the iSCSI name to the factory default value.
Issuing this command resets the adapter.
T = Restore the targets to the factory default values.
C = Restore the CHAP table to the factory default values.
V = Restore the NVRAM to the factory default values.