Qlogic 3200 Series User Manual - -Tb
6–Fibre Channel Noninteractive Commands
-tb
6-38
SN0054667-00 G
-tb
To start or stop flashing a target’s LED, issue the -tb command as follows:
# qaucli -pr fc -tb (<hba instance> | <hba wwpn>) (<target wwpn>)
(<0 | ON> | <1 | PRESET>)
-tp
Use the -tp option to show the topology configuration of the host:
# qaucli -pr fc -tp | topology
Under Linux, this feature is enabled only if you are using the 32-bit version.
-trace
To save an FCE trace of the current adapter port to a text file:
# qaucli -pr fc -trace (<hba instance> | <hba wwpn>) <file name>
Where:
-u
Use the -u option to update the firmware preload area of the adapter from a
DAT file or to save the current firmware preload area of the adapter to a DAT file.
NOTE
The <0 | ON> option flashes the LED until interrupted.
The <1 | PRESET> option flashes the LED 12 times.
This feature is supported only on JBOD (“just a bunch of disks”) devices.
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
file name = Name of the firmware preload table DAT file.
NOTE
After the trace file has been saved, send it to QLogic Technical Support (see
“Technical Support” on page xxiii
for contact information).
NOTE
The -u option is available only for the QLogic QLE2562.