Qlogic 3200 Series User Manual - -Pc
6–Fibre Channel Noninteractive Commands
-pc (Adapter Personality Change)
SN0054667-00 G
6-33
-pc
(Adapter Personality Change)
Use the -pc command to change an adapter’s personality between Fibre
Channel only (FC only) and Converged Network Adapter (CNA).
To display the adapter’s current personality, issue the -pc command as follows:
> qaucli -pr fc -pc <hba instance>|<hba wwpn>|all --info
To change the adapter’s personality, issue the -pc command as follows:
> qaucli -pr fc -pc <hba instance>|<hba wwpn>|all --type <mode>
Where:
hba instance is the adapter number
(use the -g command to find)
hba_wwpn is the worldwide port name of an adapter port
all means all adapter ports
Specify one of the following for the <mode> parameter:
Specify
fc
or
fco
or 0 to change the adapter personality to Fibre
Channel.
Specify
cna
or 1 to change the adapter personality to Converged
Network Adapter.
-pl
(Persistent Names (udev) – Linux only)
To display udev persistent device names of a specific LUN or all LUNs, issue the
following command:
# qaucli -pr fc -pl <hba instance> | <hba wwpn> --info [<target id>
Where:
NOTE
The personality feature is supported only on QLogic QLE267x and
QLE836x adapters. This feature lets you set the adapter’s personality to
Fibre Channel only or Converged Network Adapter.
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
target id = Name of the firmware preload table DAT file.
lun id
ID of the LUN
lun name
Name of the LUN