Qlogic 3200 Series User Manual - -Kr
6–Fibre Channel Noninteractive Commands
-kr (Read Write Buffer Test)
SN0054667-00 G
6-19
-kr
(Read Write Buffer Test)
Use the -kr command to run a read/write buffer test.
To run a read/write test using the default parameters, issue the following command:
# qaucli -pr fc -kr (<hba instance> | <hba wwpn>)
To run a read/write test with customized parameters, issue the following command:
# qaucli -pr fc -kr (<hba instance> | <hba wwpn>) [(-EX | -EXCLUDE)
<target wwpn>] (<param name> | <param alias>) <param value>
NOTE
To stop an active diagnostic test, press ENTER. To use an alternate key to
stop tests, modify this line in the sfcli.properties configuration file:
Default:
node.app.diag.ascii.abortkey=CR
Custom: node.app.diag.ascii.abortkey=<stop key>
Where <stop key> is any alphabetic character a–z or A–Z (uppercase
characters require pressing SHIFT+
Example 1: To set the stop key to S (press SHIFT+S to stop the test):
node.app.diag.ascii.abortkey=S
Example 2: To set the stop key to s (press S to stop the test):
node.app.diag.ascii.abortkey=s