Qlogic 3200 Series User Manual - page 95
6–Fibre Channel Noninteractive Commands
-cna (CNA FCoE Information)
SN0054667-00 G
6-9
To update the message passing interface (MPI) configuration table on the
Converged Network Adapter (81xx only) from a file, issue the following command:
qaucli -cna <hba instance>|<hba wwpn> |
To save the MPI configuration table on the Converged Network Adapter (81xx
only) to a file, issue the following command:
qaucli -cna <hba instance>|<hba wwpn> --savecfg
To view DCBX type-length-value (TLV) data sent and received over the
Converged Network Adapter port connection, issue the following command:
qaucli -cna <hba instance>|<hba wwpn> --tlv ( --detail |--raw )
The output displays the TLV of the link layer discovery protocol (LLDP) frames
meant for exchanging the parameters and their values.
To view data center Ethernet (Cisco
®
data communications equipment, DCE™)
network activity information sent and received over the Converged Network
Adapter port connection, issue the following command:
qaucli -cna <hba instance>|<hba wwpn> --mon --dce
[ { <param name> | <param alias> <param value> } ]
lists the DCE statistics parameters, possible values, and a description of
each.
Table 6-3. DCE Statistics Parameters
Parameter
Name
Parameter
Alias
Parameter
Value
Description
AutoPoll
AP
0
1–256
Set to auto polling mode
Set to manual polling mode (iteration)
SetRate
SR
5–30
Set the polling interval rate (seconds)
Details
DT
0–2
Set the detailed display mode:
0 = Absolute
1 = Rate per second
2 = Baseline