Qlogic 3200 Series User Manual - -Vp
6–Fibre Channel Noninteractive Commands
-v
SN0054667-00 G
6-39
To update the adapter firmware preload table, issue the following command:
# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) <file name>
To save the current adapter firmware preload table to a DAT file, issue the
following command:
# qaucli -pr fc -u ( <hba instance> | <hba wwpn> ) save <file name>
Where:
<hba instance> is the adapter instance number of an adapter port.
<hba wwpn> is the world wide port name of an adapter port.
<file name> is the name of the firmware preload table DAT file.
-v
To show the version number of the QConvergeConsole CLI utility, issue the -v
command as follows:
# qaucli -pr fc -v
The system shows the following information:
QConvergeConsole CLI
v1.x.x Build x
Copyright 2003-2009 QLogic Corp.
All rights reserved.
Command Line QLogic FC Host Bus Adapters.
Build Type: Release
Build Date: xx/xx/xxxx xx:xx:xx AM
-vp
(Virtual Ports [NPIV])
To list all virtual ports on a physical adapter port, issue the -vp command as
follows:
# qaucli -pr fc -vp (<hba instance> : <hba wwpn>) list all
Where:
NOTE
The -v option is valid only in noninteractive mode.
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
vport wwpn = World wide port name of the virtual port
vport hex = World wide port name of the virtual port with the two
hexadecimal digits in byte three supplied by the user