Qlogic 3200 Series User Manual - page 120
6–Fibre Channel Noninteractive Commands
-q (Target Link Speed [iiDMA])
6-34
SN0054667-00 G
If both target id and lun id are omitted, the -pl command lists all udev names
that are currently assigned to all devices attached to a physical port on the adapter.
To remove a udev persistent device name from a LUN, issue the following command:
# qaucli -pr fc -pl (<hba instance> | <hba wwpn>) --del
{<target ID>
To add a udev persistent device name to a LUN, issue the following command::
# qaucli -pr fc -pl (<hba instance> | <hba wwpn>) --set
{<target ID>
-q
(Target Link Speed [iiDMA])
To view the link speed of all targets attached to one adapter or all adapters, issue
the -q command as follows:
# qaucli -pr fc -q (<hba instance> | <hba wwpn> | <all>) [-targets
| -t ]
Where:
To view the link speed of a specific target attached to an adapter, issue the
following command:
# qaucli -pr fc -q (<hba instance> | <hba wwpn> | <target wwpn>
NOTE
Braces {} denote parameters to be specified as a group. The group can be
specified more than once. For example:
...targetID1 lunID1 lun_name1 targetID2 lunID2 lun_name2
NOTE
The -q option is supported only on 4Gb adapters.
hba instance = Adapter number (use the -g command to find)
hba wwpn = World wide port name of the adapter
all = Reports link speed for all targets on all adapters in the system
-targets = All targets
-t = All targets